Getting that air bed to inflate and deflate properly was always a challenge, until I knew what to do. Make sure the nipple valve is squeezed, so that air is allowed to enter-allowing air to enter the chamber faster...That was the easy part...The difficult part was the deflation and we all had that problem. The trick is to place the hose of the electric pump, on the other end, so that the air can be sucked out of the chambers, like a vacuum. This allowed the product to be deflated quickly and product becoming flat....the folding of the product then comes easier...The other method is to place a straw or some type of hollow chamber inside the nipple valve, so that air is allowed out while folding...It is not that difficult, once tried...Good luck..

Enter Your Comment or Question:

Please specify if this is a general comment or a question - Comment - Question

Name:

E-mail: (will not be published)

Comment / Question: (500 Char. Max)

Verification Code This step helps prevent use of automated programs that send bulk spam through this form. To counteract this practice, we ask that you type in the word below in the space provided Enter the Word exactly as it is shown in the box above: If you can't read the word, click here to load a new word